In the design of a shell and tube heat exchanger, the corrosion allowance ____________________?

A. Need not be provided for non-pressure parts like tie rods, spacers, baffles, supports etc.

B. For carbon steel and cast iron pressure parts is 1.5 mm (except for tubes) and for severe

C. ditions it is 3 mm

D. For internal cover and tube sheet is provided on both the sides

E. All A., B. & C.

Found an error? Read our corrections policy and submit a sourced correction below. You can also share a useful explanation in your own words.

Discuss the answer or suggest a sourced correction
Thank you for contributing.
Your comment was submitted and will appear after editorial review.

Your email is used only for moderation and is never displayed. Spam, copied material and fabricated endorsements are rejected.