civil engineering Mcqs
5401. The cross -sections for a highway is taken at_________________?
comments icon0

A. Right angle to the centre line

B. All the above

C. 30 metres apart

D. Intermediate points having abrupt change in gradient

5403. In the mid-section formula__________________?
comments icon0

A. The mean depth is the average of depths of two consecutive sections

B. The area of mid-sections is calculated by using mean depth

C. All of the above

D. The volume of the earth work is calculated by multiplying the mid-section area by the distance between the two original sections

5405. For the construction of buildings, the subheads of the estimate are________________?
comments icon0

A. Brickwork Flooring, Wood work, Steel work

B. Brickwork, Stone work, Roofing

C. All the above

D. Earthwork, Concrete work, Brick work

5407. Anti-siphonage pipe is connected to__________________?
comments icon0

A. Side of water closet

B. Top of P trap W.C.

C. Bottom of P trap W.C.

D. Main soil pipe

5409. The brick work is not measured in cu m in case of_______________?
comments icon0

A. Reinforced brick work

B. Half brick wall

C. One or more than one brick wall

D. Brick work in arches

5411. Pick up the correct statement from the following?
comments icon0

A. The earthwork calculation in excavation is made from the difference in levels obtained with a level

B. The earth work in excavation to form the road embankment includes the formation of correct profile and depositing the soil in layers

C. In order to check up the average depth of excavation, Dead man s are left at the mid-widths of borrow pits

D. All the above
5412. The correct Prismoidal formula for volume is________________?
comments icon0
A. D/3 [first area + last area + 4 Even area + 2 odd areas]

B. D/3 [first area + last area + 2 Even area + 4 odd areas]

C. D [first area + last area + Even area + 2 odd areas]

D. D/6 [first area + odd areas]

5413. S: 1 and length is______________?
comments icon0
A. L.D 1 + s2)

B. 2 L.D 1 + s 2)

C. d2 ( ds)2]

D. d d s

5414. Pick up the correct statement from the following?
comments icon0

A. The gully trap disconnects the sullage drain from the main drainage system

B. The grating provided over gully traps is 23 cm square

C. The gully trap collects waste water from the kitchen, sink, wash basins, etc.

D. In a gully trap, a water seal of 6 to 7.5 cm is provided

5415. Pick up the incorrect statement from the following?
comments icon0

A. Dimensions are measured to the nearest 0.01 m

B. Cubic contents are measured to the nearest 0.1 cum

C. Areas are measured to the nearest 0.01 sq.m

D. Weights are measured to the nearest 0.001 tonnes

5419. Pick up the correct statement from the following?
comments icon0

A. Detailed specifications specify qualities, quantities and the proportions of materials to be used for a particular item

B. Additional supervising staff engaged at work site, is called work charged establishment

C. The incidental expenses of a miscellaneous character which could not be predicted during preparation of the estimate, is called contingencies

D. All the above
5424. The item of steel work which is measured in sq.m, is_________________?
comments icon0

A. Collapsible gates

B. Rolling shutters

C. All the above

D. Ventilators and glazing

5425. Pick up the correct statement from the following?
comments icon0

A. The formal acceptance by the administrative department for incurring an expenditure on the work, is called administrative approval

B. The actual expenditure involved to complete a work including incidental, establishment and travelling charges, is called actual cost

C. All the above

D. The estimated value of the work excluding the amount for contingencies, work charged establishment, tool and plants, is called work value

5426. Pick up the incorrect statement regarding a master trap from the following ?
comments icon0

A. It is provided a cleaning eye at the top of the trap

B. The mica flap valve which opens inwards only, is fitted at the top of the inlet pipe

C. It is provided in between the lower end of the house drain and the street sewer

D. The water seal is less than that of ordinary traps
5428. The brick work is measured in sq metre, in case of_________________?
comments icon0
A. All the above

B. Honey comb brick work

C. Brick flat soling

D. Half brick walls or the partition

5429. period in a septic tank is assumed___________________?
comments icon0
A. 30 minutes

B. 40 minutes

C. 20 minutes

D. 25 minutes

E. detention

5430. The order of booking dimensions is________________?
comments icon0

A. None of these

B. Length, breadth, height

C. Height, breadth, length

D. Breadth, length, height

5434. Pick up the incorrect statement from the following?
comments icon0

A. The usable covered area of the rooms of any storey of a building is called carpet area

B. The carpet area of a building along with area of its kitchen, pantry, store, lavatory, bath room and glazed veranda, is called floor area

C. The built up covered area at the floor level of any storey of a building is called plinth area

D. None of these
5436. Referring of given figure, pick up the correct statement from the following?
comments icon0

A. Length of long wall out-to -out is 6.80 m

B. The total length of centre line of four walls is 20 m

C. All the above

D. Length of short walls in-to-in is 3.20 m

5437. Pick up the correct statement from the following?
comments icon0

A. If the bed level is above N.S.L. the canal is called fully in baking and the berms are designed as 3 d where d is full supply depth of water (F.S.D.)

B. If F.S.L. is above N.S.L the canal is called partly in cutting and partly in filling and berms are designed as 2d where d is full supply depth

C. All the above

D. Area of canal in cutting = BD + Sd2 where B = bed width, d = depth of cutting and S is the side slope

5438. Size, capacity and materials need be specified for__________________?
comments icon0

A. Ball valves

B. Bib-cocks

C. All the above

D. Stop-cocks

5439. Pick up the incorrect statement from the following ?
comments icon0

A. No deduction is made for volumes occupied by pipes, not exceeding 100 sq.cm in cross-section

B. None of these

C. No deduction is made for the volume occupied by reinforcement

D. No deduction is made for the openings upto 0.1 sq.m

5441. Pick up the correct statement from the following?
comments icon0

A. All pipes and fittings are classified according to their diameters

B. The diameter of the pipes is the nominal diameter of internal bore

C. All the above

D. All pipes are measured along the centre line of the pipes in metres

5442. Pick up the correct statement in case of water supply ?
comments icon0

A. Pipes laid in trenches and pipes fixed to walls are measured separately

B. All the above

C. Pipes are classified according to their sizes and quality

D. Cutting through walls and floors are included with the item

5443. Berms are provided in canals if these are__________________?
comments icon0

A. Fully in excavation

B. Fully in embankment

C. All the above

D. Partly in excavation and partly in embankment
5444. Pick up the correct statement from the following?
comments icon0
A. All the above

B. Cement is paid per 50 kg bag

C. Bricks are paid per thousand

D. Lime is paid per quintal

5445. Pick up the correct statement from the following ?
comments icon0
A. All the above

B. Pointing is measured in sq.m

C. Glazing is measured in sq.m

D. Plastering is measured in sq.m

5446. Pick up the correct statement from the following?
comments icon0

A. The bending of bars near supports is generally at 45

B. The bent up bars at a support resist the negative bending moment

C. The bent up bars at a support resist the sharing force

D. All the above