digital electronics MCQs – Page 2

Practise focused digital electronics questions with marked answers for exam preparation and subject revision.

digital electronics Mcqs
21. An OR gate has 6 inputs. The number of input words in its truth table are________________?
comments icon0
A. 64

B. 6

C. 128

D. 32

22. Digital computers are more widely used as compared to analog computers, because they are______________?
comments icon0
A. useful over wider ranges of problem types

B. easier to maintain

C. always more accurate and faster

D. less expensive

23. The binary code of (21.125)10 is_______________?
comments icon0

A. 10101.01

B. 10100.111

C. 10100.001

D. 10101.001
24. In case of OR gate, no matter what the number of inputs, a____________________?
comments icon0
A. 1 at any input causes the output to be at logic 1

B. 1 at any input causes the output to be at logic 0

C. 0 any input causes the output to be at logic 0

D. 0 at any input causes the output to be at logic 1

25. Excess-3 code is known as_________________?
comments icon0

A. Algebraic code

B. Weighted code

C. Cyclic redundancy code

D. Self-complementing code
26. Consider the representation of six-bit numbers by twos complement, ones complement, or by sign and magnitude: In which representation is there overflow from the addition of the integers 011000 and 011000 ?
comments icon0
A. All three representations

B. Twos complement and ones complement only

C. Sign and magnitude and ones complement only

D. Twos complement only

27. Indicate which of the following three binary additions are correct? 1.1011 + 1010 = 10101 II. 1010 + 1101 = 10111 ?
comments icon0
A. I and II

B. II and III

C. . 1010 + 1101 = 11111

D. II and III

E. III only

28. What would happen, if smaller logic modules are utilized for performing logical functions associated with FPGA? A. Propagation delay will increase B. FPGA area will increase C. Wastage of logic modules will not be prevented D. Number of interconnected paths in device will decrease ?
comments icon0

A. A & D

B. B & C

C. A & B

D. C & D

29. Which is the correct order of sequence for representing the input values in K-map ?
comments icon0

A. (00, 01, 11, 10)

B. (00, 01, 10, 11)

C. (00, 10, 11, 01)

D. (00, 10, 01, 11)

30. What is the octal equivalent of the binary number : 10111101 ?
comments icon0

A. 572

B. 573

C. 675

D. 275
31. What is/are the configurable functions of each and every IOBs connected around the FPGA device from the operational point of view ?
comments icon0

A. Bi-directional I/O pin access

B. Input operation

C. All of the above

D. Tristate output operation

32. Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is__________________?
comments icon0

A. CMOS

B. ECL

C. TTLLS

D. TTLAS

33. The inputs of a NAND gate are connected together. The resulting circuit is _______________?
comments icon0

A. None of the above

B. OR gate

C. NOT gate

D. AND gate

34. Positive logic in a logic circuit is one in which______________?
comments icon0

A. logic 0 and 1 are represented by 0 and positive voltage respectively

B. logic 0 and, -1 are represented by negative and positive voltages respectively

C. logic 0 voltage level is higher than logic 1 voltage level

D. logic 0 voltage level is lower than logic 1 voltage level
35. Assuming 8 bits for data, 1 bit for parity, I start bit and 2 stop bits, the number of characters that 1200 BPS communication line can transmit is__________________?
comments icon0
A. 12CPS

B. 120 CPS

C. 10 CPS

D. None of the above

36. Most of the digital computers do not have floating point hardware because_____________?
comments icon0

A. of no specific reason.

B. floating point hardware is costly

C. it is slower than software

D. it is not possible to perform floating point addition by hardware