power generation MCQs – Page 4

Practise focused power generation questions with marked answers for exam preparation and subject revision.

power generation Mcqs
62. Reheat factor in steam turbines depends on______________?
comments icon0
A. initial pressures and temperature only

B. stage efficiency only

C. exit pressure only

D. all of the above

63. Curtis turbine is_____________?
comments icon0

A. velocity compounded impulse steam turbine

B. pressure compounded impulse steam turbine

C. reaction steam turbine

D. pressure velocity compounded steam turbine
64. The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
comments icon0

A. none of the above

B. increases with number of feed heaters increasing

C. remains same unaffected by number of feed heaters

D. decreases with number of feed heaters increasing

65. The pressure on the two sides of the impulse wheel of a steam turbine_____?
comments icon0

A. increases from one side to the other side

B. is different

C. is same

D. decreases from one side to the other side

66. Incase of reaction steam turbine___________?
comments icon0
A. there is enthalpy drop both in fixed and moving blades

B. there is enthalpy drop only in fixed blades

C. there is enthalpy drop only in moving blades

D. none of the above

69. Secondary air is the air used to______________?
comments icon0

A. increase the flame length

B. reduce the flame length

C. provide air round the burners for getting optimum combustion

D. transport and dry the coal

71. In jet type condensers___________?
comments icon0

A. steam and cooling water do not mix

B. cooling water passes through tubes and steam surrounds them

C. steam passes through tubes and cooling water surrounds them

D. steam and cooling water mix
73. In a shell and tube surface condenser____________?
comments icon0
A. cooling water passes through the tubes and steam surrounds them

B. all of the above varying with situation

C. steam and cooling water mix to give the condensate

D. steam passes through the cooling tubes and cooling water surrounds them

74. In a regenerative feed heating cycle, the greatest economy is affected___________?
comments icon0

A. when steam is extracted from only one suitable point of steam turbine

B. when steam is extracted only from the last stage of steam turbine

C. when steam is extracted only from the first stage of steam turbine

D. when steam is extracted from several places in different stages of steam turbine
75. The maximum length of a screw conveyer is about___________?
comments icon0

A. 100 metres

B. 30 metres

C. 60 metres

D. 40 metres

76. The draught in locomotive boilers is produced by_____________?
comments icon0

A. forced fan

B. only motion of locomotive

C. steam jet

D. chimney

77. In a steam power plant, the function of a condenser is__________?
comments icon0

A. to condense large volumes of steam to water which may be used again in boiler

B. to maintain pressure below atmospheric to increase work output from the primemover

C. to receive large volumes of steam exhausted from steam prime mover

D. all of the above
78. Rateau steam turbine is______________?
comments icon0
A. pressure compounded impulse steam turbine

B. velocity compounded impulse steam turbine

C. pressure velocity compounded steam turbine

D. reaction steam turbine