chemical engineering MCQs – Page 336

Practise multiple-choice questions from chemical engineering for competitive examinations and subject revision. Review each marked answer and report any item that may be outdated or unclear.

chemical engineering Mcqs
6701. The temperature in isentropic flow_______________?
comments icon0
A. Depends on Mach number only

B. None of these

C. Does not depend on Mach number

D. Cannot drop and then increase again downstream

6702. Which of the following is not dimension-less ?
comments icon0

A. None of these

B. Froude number

C. Pressure co-efficient

D. Kinematic viscosity
6705. The pump impeller and the turbine runner in a hydraulic torque converter___________________?
comments icon0

A. Are directly coupled

B. Have different diameters

C. Have the same diameter

D. None of these

6706. Unsteady uniform flow is represented by flow through a/an_________________?
comments icon0
A. Long pipe at decreasing rate

B. Expanding tube at increasing rate

C. Long pipe at constant rate

D. Expanding tube at constant rate

6709. What causes convective acceleration in fluid flow ?
comments icon0

A. Turbulence in flow

B. Steep slope in flow

C. Non-uniformity of flow

D. Unsteady nature of flow

6710. Vena-contracta formed during flow of a liquid through an orificemeter has__________________?
comments icon0

A. More diameter compared to orifice diameter

B. None of these

C. Minimum velocity of fluid stream

D. Minimum liquid cross-section
6711. Gradually varied flow in open channel is a/an ____________ flow?
comments icon0

A. Unsteady uniform

B. Steady non-uniform

C. Steady uniform

D. Unsteady non-uniform

6712. Manometers measure the ______________ pressure?
comments icon0

A. Vacuum as well as the atmospheric

B. Difference in

C. Gage

D. Absolute

6714. A spherical particle is falling slow in a viscous liquid such that Reynolds number is less than 1. Which statement is correct for this situation ?
comments icon0

A. None of the above

B. Drag, gravitational and buoyancy forces are important

C. Drag force and gravitational forces are important

D. Inertial and drag forces are important

6715. Which of the following fluid forces are not considered in the Navier-Stokes equation ?
comments icon0
A. Turbulent forces

B. Gravity forces

C. Viscous forces

D. Pressure forces

6716. Cp/Cv is termed as__________________?
comments icon0

A. Mach number

B. Adiabatic constant

C. Prandtl number

D. Weber number

6718. Velocity at a certain point in case of streamline flow is_________________?
comments icon0

A. Constant

B. Independent of time

C. Both A. & B.

D. Neither A. nor B.

6719. Fluid flow at increasing rate through a diverging pipe is an example of ______________ flow?
comments icon0

A. Steady uniform

B. Non-steady uniform

C. Non-steady non-uniform

D. Steady non-uniform

6720. A differential pressure cell is used for____________________________?
comments icon0

A. Measuring small pressure difference in liquids

B. Remote recording of pressure difference

C. Measuring the difference of the impact & the static pressure

D. Measuring small pressure difference in gases