chemical engineering fuels and combustion MCQs – Page 17

Practise multiple-choice questions from chemical engineering fuels and combustion for competitive examinations and subject revision. Review each marked answer and report any item that may be outdated or unclear.

chemical engineering fuels and combustion Mcqs
321. The heat of combustion of a fuel___________________?
comments icon0

A. Is equal to the heat of formation

B. Is always negative

C. Cant be known without calculating it

D. Is always positive

323. Fusion point of coal ash increases with increase in its ____________ content?
comments icon0

A. Iron silicate

B. All A., B. and C.

C. Iron sulphate

D. Lime and magnesia

324. Height of coke oven is limited (say maximum upto 7 metres) mainly by the_____________________?
comments icon0

A. Structural strength of silica bricks

B. Problem in door cleaning

C. Buckling of ram of pusher car at the time of coke pushing

D. Problem of uniform heating along its height
326. Benzol is used_____________________?
comments icon0

A. As a motor fuel blend

B. For producing benzene, toluene & xylene by its distillation

C. Both A. & B.

D. Neither A. nor B.

328. Prime coking coal is always blended with medium or non- coking coal before carbonisation__________________?
comments icon0

A. To check against its excessive swelling during heating, which may exert high pressure and

B. age coke oven walls

C. Because, it alone produces unreactive coke

D. Both A. and B.

E. Neither A. nor B.

329. In low temperature carbonisation of coal, the________________?
comments icon0

A. Volatile matter in coke is zero

B. Yield of tar is about 3% of dry coal

C. Yield of coke oven gas is 290 Nm3 /ton dry coal

D. Temperature maintained is 700C
330. A coal having high amount of volatile matter____________________?
comments icon0

A. Ignites easily and burns with long smoky flame

B. All A., B. and C.

C. Would require smaller combustion chamber

D. Produces very little of tar and gas on carbonisation

331. Calorific value of ____________________?
comments icon0

A. Light paraffinic fuel oils is equal to that of equivalent olefins

B. Light paraffinic fuel oils is higher than that of equivalent olefins

C. Light paraffinic fuel oils is lower than that of equivalent olefins

D. n-paraffin is lower than that of iso-paraffins of the same compounds

333. Gray King Assay and Swelling Index of a coal is a measure of its ____________________?
comments icon0

A. Resistance to impact breakage

B. Agglutinating properties

C. Swelling characteristics

D. Abradability

335. Preheating of a gaseous fuel results in increased____________________?
comments icon0
A. Flame temperature

B. Quantity of flue gas

C. Flame length

D. Ignition temperature

336. Calorific value as determined by bomb calorimeter is the__________________?
comments icon0

A. Lower calorific value at constant pressure

B. Higher calorific value at constant volume

C. Net calorific value at constant volume

D. Gross calorific value at constant pressure

338. Bituminous coal___________________?
comments icon0

A. Ignites less easily than anthracite

B. Is generally coking

C. Burns with smoky yellow flame

D. Both B. and C.
340. The optimum percentage of excess air for combustion depends upon the _______________ of the fuel?
comments icon0

A. Sulphur content

B. Ignition temperature

C. Type (solid, liquid or gaseous)

D. Calorific value